acx_config.h

   1 #ifndef _ACX_CONFIG_H_
   2 #define _ACX_CONFIG_H_
   3
   4 /* temporary hack until proper Kconfig integration */
   5 #define CONFIG_ACX_MAC80211_PCI 1
   6 //#define CONFIG_ACX_MAC80211_USB 1
   7
   8 /*
   9  * Err out immediately if both are set
  10  */
  11
  12 #if defined(CONFIG_ACX_MAC80211_PCI) && defined(CONFIG_ACX_MAC80211_USB)
  13 #error The driver does NOT support building both USB and PCI at the moment
  14 #endif
  15
  16 /*
  17  * Also err out if none is set...
  18  */
  19 #if !(defined(CONFIG_ACX_MAC80211_PCI) || defined(CONFIG_ACX_MAC80211_USB))
  20 #error Driver must include PCI and/or USB support. You selected neither.
  21 #endif
  22
  23
  24 #define ACX_RELEASE "v0.3.38-mac80211"
  25
  26 /* assume 32bit I/O width
  27  * (16bit is also compatible with Compact Flash) */
  28 #define ACX_IO_WIDTH 32
  29
  30 /* Set this to 1 if you want monitor mode to use
  31  * phy header. Currently it is not useful anyway since we
  32  * don't know what useful info (if any) is in phy header.
  33  * If you want faster/smaller code, say 0 here */
  34 #define WANT_PHY_HDR 0
  35
  36 /* whether to do Tx descriptor cleanup in softirq (i.e. not in IRQ
  37  * handler) or not. Note that doing it later does slightly increase
  38  * system load, so still do that stuff in the IRQ handler for now,
  39  * even if that probably means worse latency */
  40 #define TX_CLEANUP_IN_SOFTIRQ 0
  41
  42 /* if you want very experimental 802.11 power save mode features */
  43 #define POWER_SAVE_80211 0
  44
  45 /* if you want very early packet fragmentation bits and pieces */
  46 #define ACX_FRAGMENTATION 0
  47
  48 /* Locking: */
  49 /* very talkative */
  50 #define PARANOID_LOCKING 1
  51 /* normal (use when bug-free) */
  52 /* #define DO_LOCKING 1 */
  53 /* else locking is disabled! */
  54
  55 /* 0 - normal mode */
  56 /* 1 - development/debug: probe for IEs on modprobe */
  57 #define CMD_DISCOVERY 0
  58
  59 #endif /* _ACX_CONFIG_H_ */