release/src-rt-6.x.4708/shared/nvram/bcm94702ap-sw.txt

   1 # BCM94702AP board as l2 switch
   2 # $Copyright Open Broadcom Corporation$
   3 # $Id: bcm94702ap-sw.txt,v 1.2 2004-12-15 21:09:29 rtrask Exp $
   4 boardtype=bcm94710ap
   5 boardnum=${serno}
   6
   7 # 4702 CPU clock frequency in Mhz
   8 # Only valid value is 125, anything else defaults to 100Mhz
   9 clkfreq=125
  10
  11 # 4702 SDRAM controller parameters
  12 sdram_init=0x0419
  13 sdram_config=0x0000
  14 sdram_refresh=0x8040
  15 sdram_ncdl=0
  16
  17 # 4702 MAC and PHY parameters
  18 et0macaddr=00:90:4c:49:${maclo}
  19 et0phyaddr=30
  20 et0mdcport=0
  21 et1macaddr=00:90:4c:4a:${maclo}
  22 et1phyaddr=5
  23 et1mdcport=1
  24
  25 # PMON variables
  26 dl_ram_addr=a0001000
  27 os_ram_addr=80001000
  28 os_flash_addr=bfc40000
  29 lan_ipaddr=192.168.1.1
  30 lan_netmask=255.255.255.0
  31 scratch=a0180000
  32 boot_wait=on
  33
  34 # watchdog set to 3 sec
  35 watchdog=3000
  36
  37 # glue between bootloader and firmware
  38 landevs=et0 et1 wl0 wl1
  39 wandevs=