release/src-rt-6.x.4708/linux/linux-2.6.36/drivers/serial/crisv10.h

   1 /*
   2  * serial.h: Arch-dep definitions for the Etrax100 serial driver.
   3  *
   4  * Copyright (C) 1998-2007 Axis Communications AB
   5  */
   6
   7 #ifndef _ETRAX_SERIAL_H
   8 #define _ETRAX_SERIAL_H
   9
  10 #include <linux/circ_buf.h>
  11 #include <asm/termios.h>
  12 #include <asm/dma.h>
  13 #include <arch/io_interface_mux.h>
  14
  15 /* Software state per channel */
  16
  17 #ifdef __KERNEL__
  18 /*
  19  * This is our internal structure for each serial port's state.
  20  *
  21  * Many fields are paralleled by the structure used by the serial_struct
  22  * structure.
  23  *
  24  * For definitions of the flags field, see tty.h
  25  */
  26
  27 #define SERIAL_RECV_DESCRIPTORS 8
  28
  29 struct etrax_recv_buffer {
  30         struct etrax_recv_buffer *next;
  31         unsigned short length;
  32         unsigned char error;
  33         unsigned char pad;
  34
  35         unsigned char buffer[0];
  36 };
  37
  38 struct e100_serial {
  39         struct tty_port port;
  40         int baud;
  41         volatile u8     *ioport;        /* R_SERIALx_CTRL */
  42         u32             irq;    /* bitnr in R_IRQ_MASK2 for dmaX_descr */
  43
  44         /* Output registers */
  45         volatile u8 *oclrintradr;       /* adr to R_DMA_CHx_CLR_INTR */
  46         volatile u32 *ofirstadr;        /* adr to R_DMA_CHx_FIRST */
  47         volatile u8 *ocmdadr;           /* adr to R_DMA_CHx_CMD */
  48         const volatile u8 *ostatusadr;  /* adr to R_DMA_CHx_STATUS */
  49
  50         /* Input registers */
  51         volatile u8 *iclrintradr;       /* adr to R_DMA_CHx_CLR_INTR */
  52         volatile u32 *ifirstadr;        /* adr to R_DMA_CHx_FIRST */
  53         volatile u8 *icmdadr;           /* adr to R_DMA_CHx_CMD */
  54         volatile u32 *idescradr;        /* adr to R_DMA_CHx_DESCR */
  55
  56         int flags;      /* defined in tty.h */
  57
  58         u8 rx_ctrl;     /* shadow for R_SERIALx_REC_CTRL */
  59         u8 tx_ctrl;     /* shadow for R_SERIALx_TR_CTRL */
  60         u8 iseteop;     /* bit number for R_SET_EOP for the input dma */
  61         int enabled;    /* Set to 1 if the port is enabled in HW config */
  62
  63         u8 dma_out_enabled;     /* Set to 1 if DMA should be used */
  64         u8 dma_in_enabled;      /* Set to 1 if DMA should be used */
  65
  66         /* end of fields defined in rs_table[] in .c-file */
  67         int             dma_owner;
  68         unsigned int    dma_in_nbr;
  69         unsigned int    dma_out_nbr;
  70         unsigned int    dma_in_irq_nbr;
  71         unsigned int    dma_out_irq_nbr;
  72         unsigned long   dma_in_irq_flags;
  73         unsigned long   dma_out_irq_flags;
  74         char            *dma_in_irq_description;
  75         char            *dma_out_irq_description;
  76
  77         enum cris_io_interface io_if;
  78         char            *io_if_description;
  79
  80         u8              uses_dma_in;  /* Set to 1 if DMA is used */
  81         u8              uses_dma_out; /* Set to 1 if DMA is used */
  82         u8              forced_eop;   /* a fifo eop has been forced */
  83         int                     baud_base;     /* For special baudrates */
  84         int                     custom_divisor; /* For special baudrates */
  85         struct etrax_dma_descr  tr_descr;
  86         struct etrax_dma_descr  rec_descr[SERIAL_RECV_DESCRIPTORS];
  87         int                     cur_rec_descr;
  88
  89         volatile int            tr_running; /* 1 if output is running */
  90
  91         struct tty_struct       *tty;
  92         int                     read_status_mask;
  93         int                     ignore_status_mask;
  94         int                     x_char; /* xon/xoff character */
  95         int                     close_delay;
  96         unsigned short          closing_wait;
  97         unsigned short          closing_wait2;
  98         unsigned long           event;
  99         unsigned long           last_active;
 100         int                     line;
 101         int                     type;  /* PORT_ETRAX */
 102         int                     count;      /* # of fd on device */
 103         int                     blocked_open; /* # of blocked opens */
 104         struct circ_buf         xmit;
 105         struct etrax_recv_buffer *first_recv_buffer;
 106         struct etrax_recv_buffer *last_recv_buffer;
 107         unsigned int            recv_cnt;
 108         unsigned int            max_recv_cnt;
 109
 110         struct work_struct      work;
 111         struct async_icount     icount;   /* error-statistics etc.*/
 112         struct ktermios         normal_termios;
 113         struct ktermios         callout_termios;
 114         wait_queue_head_t       open_wait;
 115         wait_queue_head_t       close_wait;
 116
 117         unsigned long char_time_usec;       /* The time for 1 char, in usecs */
 118         unsigned long flush_time_usec;      /* How often we should flush */
 119         unsigned long last_tx_active_usec;  /* Last tx usec in the jiffies */
 120         unsigned long last_tx_active;       /* Last tx time in jiffies */
 121         unsigned long last_rx_active_usec;  /* Last rx usec in the jiffies */
 122         unsigned long last_rx_active;       /* Last rx time in jiffies */
 123
 124         int break_detected_cnt;
 125         int errorcode;
 126
 127 #ifdef CONFIG_ETRAX_RS485
 128         struct serial_rs485     rs485;  /* RS-485 support */
 129 #endif
 130 };
 131
 132 /* this PORT is not in the standard serial.h. it's not actually used for
 133  * anything since we only have one type of async serial-port anyway in this
 134  * system.
 135  */
 136
 137 #define PORT_ETRAX 1
 138
 139 /*
 140  * Events are used to schedule things to happen at timer-interrupt
 141  * time, instead of at rs interrupt time.
 142  */
 143 #define RS_EVENT_WRITE_WAKEUP   0
 144
 145 #endif /* __KERNEL__ */
 146
 147 #endif /* !_ETRAX_SERIAL_H */