2 * QEMU Sparc32 DMA controller emulation
4 * Copyright (c) 2006 Fabrice Bellard
7 * 2010-Feb-14 Artyom Tarasenko : reworked irq generation
9 * Permission is hereby granted, free of charge, to any person obtaining a copy
10 * of this software and associated documentation files (the "Software"), to deal
11 * in the Software without restriction, including without limitation the rights
12 * to use, copy, modify, merge, publish, distribute, sublicense, and/or sell
13 * copies of the Software, and to permit persons to whom the Software is
14 * furnished to do so, subject to the following conditions:
16 * The above copyright notice and this permission notice shall be included in
17 * all copies or substantial portions of the Software.
19 * THE SOFTWARE IS PROVIDED "AS IS", WITHOUT WARRANTY OF ANY KIND, EXPRESS OR
20 * IMPLIED, INCLUDING BUT NOT LIMITED TO THE WARRANTIES OF MERCHANTABILITY,
21 * FITNESS FOR A PARTICULAR PURPOSE AND NONINFRINGEMENT. IN NO EVENT SHALL
22 * THE AUTHORS OR COPYRIGHT HOLDERS BE LIABLE FOR ANY CLAIM, DAMAGES OR OTHER
23 * LIABILITY, WHETHER IN AN ACTION OF CONTRACT, TORT OR OTHERWISE, ARISING FROM,
24 * OUT OF OR IN CONNECTION WITH THE SOFTWARE OR THE USE OR OTHER DEALINGS IN
29 #include "sparc32_dma.h"
35 * This is the DMA controller part of chip STP2000 (Master I/O), also
36 * produced as NCR89C100. See
37 * http://www.ibiblio.org/pub/historic-linux/early-ports/Sparc/NCR/NCR89C100.txt
39 * http://www.ibiblio.org/pub/historic-linux/early-ports/Sparc/NCR/DMA2.txt
43 #define DMA_SIZE (4 * sizeof(uint32_t))
44 /* We need the mask, because one instance of the device is not page
45 aligned (ledma, start address 0x0010) */
46 #define DMA_MASK (DMA_SIZE - 1)
47 /* OBP says 0x20 bytes for ledma, the extras are aliased to espdma */
48 #define DMA_ETH_SIZE (8 * sizeof(uint32_t))
49 #define DMA_MAX_REG_OFFSET (2 * DMA_SIZE - 1)
51 #define DMA_VER 0xa0000000
53 #define DMA_INTREN 0x10
54 #define DMA_WRITE_MEM 0x100
56 #define DMA_LOADED 0x04000000
57 #define DMA_DRAIN_FIFO 0x40
58 #define DMA_RESET 0x80
60 /* XXX SCSI and ethernet should have different read-only bit masks */
61 #define DMA_CSR_RO_MASK 0xfe000007
63 typedef struct DMAState DMAState
;
68 uint32_t dmaregs
[DMA_REGS
];
80 /* Note: on sparc, the lance 16 bit bus is swapped */
81 void ledma_memory_read(void *opaque
, hwaddr addr
,
82 uint8_t *buf
, int len
, int do_bswap
)
87 addr
|= s
->dmaregs
[3];
88 trace_ledma_memory_read(addr
);
90 sparc_iommu_memory_read(s
->iommu
, addr
, buf
, len
);
94 sparc_iommu_memory_read(s
->iommu
, addr
, buf
, len
);
95 for(i
= 0; i
< len
; i
+= 2) {
96 bswap16s((uint16_t *)(buf
+ i
));
101 void ledma_memory_write(void *opaque
, hwaddr addr
,
102 uint8_t *buf
, int len
, int do_bswap
)
104 DMAState
*s
= opaque
;
106 uint16_t tmp_buf
[32];
108 addr
|= s
->dmaregs
[3];
109 trace_ledma_memory_write(addr
);
111 sparc_iommu_memory_write(s
->iommu
, addr
, buf
, len
);
117 if (l
> sizeof(tmp_buf
))
119 for(i
= 0; i
< l
; i
+= 2) {
120 tmp_buf
[i
>> 1] = bswap16(*(uint16_t *)(buf
+ i
));
122 sparc_iommu_memory_write(s
->iommu
, addr
, (uint8_t *)tmp_buf
, l
);
130 static void dma_set_irq(void *opaque
, int irq
, int level
)
132 DMAState
*s
= opaque
;
134 s
->dmaregs
[0] |= DMA_INTR
;
135 if (s
->dmaregs
[0] & DMA_INTREN
) {
136 trace_sparc32_dma_set_irq_raise();
137 qemu_irq_raise(s
->irq
);
140 if (s
->dmaregs
[0] & DMA_INTR
) {
141 s
->dmaregs
[0] &= ~DMA_INTR
;
142 if (s
->dmaregs
[0] & DMA_INTREN
) {
143 trace_sparc32_dma_set_irq_lower();
144 qemu_irq_lower(s
->irq
);
150 void espdma_memory_read(void *opaque
, uint8_t *buf
, int len
)
152 DMAState
*s
= opaque
;
154 trace_espdma_memory_read(s
->dmaregs
[1]);
155 sparc_iommu_memory_read(s
->iommu
, s
->dmaregs
[1], buf
, len
);
156 s
->dmaregs
[1] += len
;
159 void espdma_memory_write(void *opaque
, uint8_t *buf
, int len
)
161 DMAState
*s
= opaque
;
163 trace_espdma_memory_write(s
->dmaregs
[1]);
164 sparc_iommu_memory_write(s
->iommu
, s
->dmaregs
[1], buf
, len
);
165 s
->dmaregs
[1] += len
;
168 static uint64_t dma_mem_read(void *opaque
, hwaddr addr
,
171 DMAState
*s
= opaque
;
174 if (s
->is_ledma
&& (addr
> DMA_MAX_REG_OFFSET
)) {
175 /* aliased to espdma, but we can't get there from here */
176 /* buggy driver if using undocumented behavior, just return 0 */
177 trace_sparc32_dma_mem_readl(addr
, 0);
180 saddr
= (addr
& DMA_MASK
) >> 2;
181 trace_sparc32_dma_mem_readl(addr
, s
->dmaregs
[saddr
]);
182 return s
->dmaregs
[saddr
];
185 static void dma_mem_write(void *opaque
, hwaddr addr
,
186 uint64_t val
, unsigned size
)
188 DMAState
*s
= opaque
;
191 if (s
->is_ledma
&& (addr
> DMA_MAX_REG_OFFSET
)) {
192 /* aliased to espdma, but we can't get there from here */
193 trace_sparc32_dma_mem_writel(addr
, 0, val
);
196 saddr
= (addr
& DMA_MASK
) >> 2;
197 trace_sparc32_dma_mem_writel(addr
, s
->dmaregs
[saddr
], val
);
200 if (val
& DMA_INTREN
) {
201 if (s
->dmaregs
[0] & DMA_INTR
) {
202 trace_sparc32_dma_set_irq_raise();
203 qemu_irq_raise(s
->irq
);
206 if (s
->dmaregs
[0] & (DMA_INTR
| DMA_INTREN
)) {
207 trace_sparc32_dma_set_irq_lower();
208 qemu_irq_lower(s
->irq
);
211 if (val
& DMA_RESET
) {
212 qemu_irq_raise(s
->gpio
[GPIO_RESET
]);
213 qemu_irq_lower(s
->gpio
[GPIO_RESET
]);
214 } else if (val
& DMA_DRAIN_FIFO
) {
215 val
&= ~DMA_DRAIN_FIFO
;
217 val
= DMA_DRAIN_FIFO
;
219 if (val
& DMA_EN
&& !(s
->dmaregs
[0] & DMA_EN
)) {
220 trace_sparc32_dma_enable_raise();
221 qemu_irq_raise(s
->gpio
[GPIO_DMA
]);
222 } else if (!(val
& DMA_EN
) && !!(s
->dmaregs
[0] & DMA_EN
)) {
223 trace_sparc32_dma_enable_lower();
224 qemu_irq_lower(s
->gpio
[GPIO_DMA
]);
227 val
&= ~DMA_CSR_RO_MASK
;
229 s
->dmaregs
[0] = (s
->dmaregs
[0] & DMA_CSR_RO_MASK
) | val
;
232 s
->dmaregs
[0] |= DMA_LOADED
;
235 s
->dmaregs
[saddr
] = val
;
240 static const MemoryRegionOps dma_mem_ops
= {
241 .read
= dma_mem_read
,
242 .write
= dma_mem_write
,
243 .endianness
= DEVICE_NATIVE_ENDIAN
,
245 .min_access_size
= 4,
246 .max_access_size
= 4,
250 static void dma_reset(DeviceState
*d
)
252 DMAState
*s
= container_of(d
, DMAState
, busdev
.qdev
);
254 memset(s
->dmaregs
, 0, DMA_SIZE
);
255 s
->dmaregs
[0] = DMA_VER
;
258 static const VMStateDescription vmstate_dma
= {
259 .name
="sparc32_dma",
261 .minimum_version_id
= 2,
262 .minimum_version_id_old
= 2,
263 .fields
= (VMStateField
[]) {
264 VMSTATE_UINT32_ARRAY(dmaregs
, DMAState
, DMA_REGS
),
265 VMSTATE_END_OF_LIST()
269 static int sparc32_dma_init1(SysBusDevice
*dev
)
271 DMAState
*s
= FROM_SYSBUS(DMAState
, dev
);
274 sysbus_init_irq(dev
, &s
->irq
);
276 reg_size
= s
->is_ledma
? DMA_ETH_SIZE
: DMA_SIZE
;
277 memory_region_init_io(&s
->iomem
, &dma_mem_ops
, s
, "dma", reg_size
);
278 sysbus_init_mmio(dev
, &s
->iomem
);
280 qdev_init_gpio_in(&dev
->qdev
, dma_set_irq
, 1);
281 qdev_init_gpio_out(&dev
->qdev
, s
->gpio
, 2);
286 static Property sparc32_dma_properties
[] = {
287 DEFINE_PROP_PTR("iommu_opaque", DMAState
, iommu
),
288 DEFINE_PROP_UINT32("is_ledma", DMAState
, is_ledma
, 0),
289 DEFINE_PROP_END_OF_LIST(),
292 static void sparc32_dma_class_init(ObjectClass
*klass
, void *data
)
294 DeviceClass
*dc
= DEVICE_CLASS(klass
);
295 SysBusDeviceClass
*k
= SYS_BUS_DEVICE_CLASS(klass
);
297 k
->init
= sparc32_dma_init1
;
298 dc
->reset
= dma_reset
;
299 dc
->vmsd
= &vmstate_dma
;
300 dc
->props
= sparc32_dma_properties
;
303 static const TypeInfo sparc32_dma_info
= {
304 .name
= "sparc32_dma",
305 .parent
= TYPE_SYS_BUS_DEVICE
,
306 .instance_size
= sizeof(DMAState
),
307 .class_init
= sparc32_dma_class_init
,
310 static void sparc32_dma_register_types(void)
312 type_register_static(&sparc32_dma_info
);
315 type_init(sparc32_dma_register_types
)