2 .\" This manpage is Copyright (C) 1996 Michael Haardt.
3 .\" Updates Nov 1998, Andries Brouwer
5 .\" %%%LICENSE_START(VERBATIM)
6 .\" Permission is granted to make and distribute verbatim copies of this
7 .\" manual provided the copyright notice and this permission notice are
8 .\" preserved on all copies.
10 .\" Permission is granted to copy and distribute modified versions of this
11 .\" manual under the conditions for verbatim copying, provided that the
12 .\" entire resulting derived work is distributed under the terms of a
13 .\" permission notice identical to this one.
15 .\" Since the Linux kernel and libraries are constantly changing, this
16 .\" manual page may be incorrect or out-of-date. The author(s) assume no
17 .\" responsibility for errors or omissions, or for damages resulting from
18 .\" the use of the information contained herein. The author(s) may not
19 .\" have taken the same level of care in the production of this manual,
20 .\" which is licensed free of charge, as they might when working
23 .\" Formatted or processed versions of this manual, if unaccompanied by
24 .\" the source, must acknowledge the copyright and authors of this work.
26 .TH MOUSE 4 2016-10-08 "Linux" "Linux Programmer's Manual"
28 mouse \- serial mouse interface
30 Serial mice are connected to a serial RS232/V24 dialout line, see
35 The pinout of the usual 9 pin plug as used for serial mice is:
41 3 TX \-12 V, Imax = 10 mA
42 4 DTR +12 V, Imax = 10 mA
43 7 RTS +12 V, Imax = 10 mA
47 This is the specification, in fact 9 V suffices with most mice.
49 The mouse driver can recognize a mouse by dropping RTS to low and raising
51 About 14 ms later the mouse will send 0x4D (\(aqM\(aq) on the data line.
52 After a further 63 ms, a Microsoft-compatible 3-button mouse will send
55 The relative mouse movement is sent as
57 (positive means right)
60 (positive means down).
61 Various mice can operate at different speeds.
62 To select speeds, cycle through the
63 speeds 9600, 4800, 2400, and 1200 bit/s, each time writing the two characters
64 from the table below and waiting 0.1 seconds.
65 The following table shows available speeds and the strings that select them:
76 The first byte of a data packet can be used for synchronization purposes.
77 .SS Microsoft protocol
80 protocol uses 1 start bit, 7 data bits, no parity
81 and one stop bit at the speed of 1200 bits/sec.
82 Data is sent to RxD in 3-byte packets.
91 are set when the left (right)
97 byte d6 d5 d4 d3 d2 d1 d0
98 1 1 lb rb dy7 dy6 dx7 dx6
99 2 0 dx5 dx4 dx3 dx2 dx1 dx0
100 3 0 dy5 dy4 dy3 dy2 dy1 dy0
103 .SS 3-button Microsoft protocol
104 Original Microsoft mice only have two buttons.
105 However, there are some
106 three button mice which also use the Microsoft protocol.
108 releasing the middle button is reported by sending a packet with zero
109 movement and no buttons pressed.
110 (Thus, unlike for the other two buttons, the status of the middle
111 button is not reported in each packet.)
112 .SS Logitech protocol
113 Logitech serial 3-button mice use a different extension of the
114 Microsoft protocol: when the middle button is up, the above 3-byte
116 When the middle button is down a 4-byte packet is
117 sent, where the 4th byte has value 0x20 (or at least has the 0x20
119 In particular, a press of the middle button is reported
120 as 0,0,0,0x20 when no other buttons are down.
121 .SS Mousesystems protocol
124 protocol uses 1 start bit, 8 data bits, no parity
125 and two stop bits at the speed of 1200 bits/sec.
126 Data is sent to RxD in
129 is sent as the sum of the two two's-complement
132 is send as negated sum of the two two's-complement
137 are cleared when the left (middle,
138 right) button is pressed:
143 byte d7 d6 d5 d4 d3 d2 d1 d0
145 2 0 dxa6 dxa5 dxa4 dxa3 dxa2 dxa1 dxa0
146 3 0 dya6 dya5 dya4 dya3 dya2 dya1 dya0
147 4 0 dxb6 dxb5 dxb4 dxb3 dxb2 dxb1 dxb0
148 5 0 dyb6 dyb5 dyb4 dyb3 dyb2 dyb1 dyb0
152 Bytes 4 and 5 describe the change that occurred since bytes 2 and 3
157 protocol is the 3-byte version of the above 5-byte
158 Mousesystems protocol: the last two bytes are not sent.
162 protocol uses 1 start bit, 8 data bits, odd parity and one
163 stop bit at the speed of 1200 bits/sec.
164 Data is sent to RxD in 3-byte
169 are sent as single signed values, the
170 sign bit indicating a negative value.
175 set when the left (middle, right) button is pressed:
180 byte d7 d6 d5 d4 d3 d2 d1 d0
181 1 1 0 0 dxs dys lb mb rb
182 2 0 dx6 dx5 dx4 dx3 dx2 dx1 dx0
183 3 0 dy6 dy5 dy4 dy3 dy2 dy1 dy0
189 A commonly used symbolic link pointing to a mouse device.