2 * This file is subject to the terms and conditions of the GNU General Public
3 * License. See the file "COPYING" in the main directory of this archive
6 * Copyright (c) 2005 Silicon Graphics, Inc. All Rights Reserved.
12 #include <linux/interrupt.h>
18 /* Miscellaneous values inherent to hardware */
20 #define IOC4_EXTINT_COUNT_DIVISOR 520 /* PCI clocks per COUNT tick */
22 /***********************************
23 * Structures needed by subdrivers *
24 ***********************************/
26 /* This structure fully describes the IOC4 miscellaneous registers which
27 * appear at bar[0]+0x00000 through bar[0]+0x0005c. The corresponding
28 * PCI resource is managed by the main IOC4 driver because it contains
29 * registers of interest to many different IOC4 subdrivers.
31 struct ioc4_misc_regs
{
32 /* Miscellaneous IOC4 registers */
33 union ioc4_pci_err_addr_l
{
36 uint32_t valid
:1; /* Address captured */
37 uint32_t master_id
:4; /* Unit causing error
38 * 0/1: Serial port 0 TX/RX
39 * 2/3: Serial port 1 TX/RX
40 * 4/5: Serial port 2 TX/RX
41 * 6/7: Serial port 3 TX/RX
45 uint32_t mul_err
:1; /* Multiple errors occurred */
46 uint32_t addr
:26; /* Bits 31-6 of error addr */
49 uint32_t pci_err_addr_h
; /* Bits 63-32 of error addr */
53 uint8_t tx_mt
:1; /* TX ring buffer empty */
54 uint8_t rx_full
:1; /* RX ring buffer full */
55 uint8_t rx_high
:1; /* RX high-water exceeded */
56 uint8_t rx_timer
:1; /* RX timer has triggered */
57 uint8_t delta_dcd
:1; /* DELTA_DCD seen */
58 uint8_t delta_cts
:1; /* DELTA_CTS seen */
59 uint8_t intr_pass
:1; /* Interrupt pass-through */
60 uint8_t tx_explicit
:1; /* TX, MCW, or delay complete */
62 } sio_ir
; /* Serial interrupt state */
63 union ioc4_other_int
{
66 uint32_t ata_int
:1; /* ATA port passthru */
67 uint32_t ata_memerr
:1; /* ATA halted by mem error */
68 uint32_t memerr
:4; /* Serial halted by mem err */
69 uint32_t kbd_int
:1; /* kbd/mouse intr asserted */
70 uint32_t reserved
:16; /* zero */
71 uint32_t rt_int
:1; /* INT_OUT section latch */
72 uint32_t gen_int
:8; /* Intr. from generic pins */
74 } other_ir
; /* Other interrupt state */
75 union ioc4_sio_int sio_ies
; /* Serial interrupt enable set */
76 union ioc4_other_int other_ies
; /* Other interrupt enable set */
77 union ioc4_sio_int sio_iec
; /* Serial interrupt enable clear */
78 union ioc4_other_int other_iec
; /* Other interrupt enable clear */
82 uint32_t cmd_pulse
:4; /* Bytebus strobe width */
83 uint32_t arb_diag
:3; /* PCI bus requester */
84 uint32_t sio_diag_idle
:1; /* Active ser req? */
85 uint32_t ata_diag_idle
:1; /* Active ATA req? */
86 uint32_t ata_diag_active
:1; /* ATA req is winner */
87 uint32_t reserved
:22; /* zero */
94 uint32_t count
:16; /* Period control */
95 uint32_t mode
:3; /* Output signal shape */
96 uint32_t reserved
:11; /* zero */
97 uint32_t diag
:1; /* Timebase control */
98 uint32_t int_out
:1; /* Current value */
100 } int_out
; /* External interrupt output control */
105 uint32_t dir
:8; /* Pin direction */
106 uint32_t edge
:8; /* Edge/level mode */
107 uint32_t reserved1
:4; /* zero */
108 uint32_t int_out_en
:1; /* INT_OUT enable */
109 uint32_t reserved2
:11; /* zero */
111 } gpcr_s
; /* Generic PIO control set */
112 union ioc4_gpcr gpcr_c
; /* Generic PIO control clear */
116 uint32_t gen_pin
:8; /* State of pins */
117 uint32_t reserved
:24;
119 } gpdr
; /* Generic PIO data */
124 uint32_t gen_pin
:1; /* Single pin state */
125 uint32_t reserved
:31;
127 } gppr
[8]; /* Generic PIO pins */
130 /* Masks for GPCR DIR pins */
131 #define IOC4_GPCR_DIR_0 0x01 /* External interrupt output */
132 #define IOC4_GPCR_DIR_1 0x02 /* External interrupt input */
133 #define IOC4_GPCR_DIR_2 0x04
134 #define IOC4_GPCR_DIR_3 0x08 /* Keyboard/mouse presence */
135 #define IOC4_GPCR_DIR_4 0x10 /* Ser. port 0 xcvr select (0=232, 1=422) */
136 #define IOC4_GPCR_DIR_5 0x20 /* Ser. port 1 xcvr select (0=232, 1=422) */
137 #define IOC4_GPCR_DIR_6 0x40 /* Ser. port 2 xcvr select (0=232, 1=422) */
138 #define IOC4_GPCR_DIR_7 0x80 /* Ser. port 3 xcvr select (0=232, 1=422) */
140 /* Masks for GPCR EDGE pins */
141 #define IOC4_GPCR_EDGE_0 0x01
142 #define IOC4_GPCR_EDGE_1 0x02 /* External interrupt input */
143 #define IOC4_GPCR_EDGE_2 0x04
144 #define IOC4_GPCR_EDGE_3 0x08
145 #define IOC4_GPCR_EDGE_4 0x10
146 #define IOC4_GPCR_EDGE_5 0x20
147 #define IOC4_GPCR_EDGE_6 0x40
148 #define IOC4_GPCR_EDGE_7 0x80
150 #define IOC4_VARIANT_IO9 0x0900
151 #define IOC4_VARIANT_PCI_RT 0x0901
152 #define IOC4_VARIANT_IO10 0x1000
154 /* One of these per IOC4 */
155 struct ioc4_driver_data
{
156 struct list_head idd_list
;
157 unsigned long idd_bar0
;
158 struct pci_dev
*idd_pdev
;
159 const struct pci_device_id
*idd_pci_id
;
160 struct __iomem ioc4_misc_regs
*idd_misc_regs
;
161 unsigned long count_period
;
162 void *idd_serial_data
;
163 unsigned int idd_variant
;
166 /* One per submodule */
167 struct ioc4_submodule
{
168 struct list_head is_list
;
170 struct module
*is_owner
;
171 int (*is_probe
) (struct ioc4_driver_data
*);
172 int (*is_remove
) (struct ioc4_driver_data
*);
175 #define IOC4_NUM_CARDS 8 /* max cards per partition */
177 /**********************************
178 * Functions needed by submodules *
179 **********************************/
181 extern int ioc4_register_submodule(struct ioc4_submodule
*);
182 extern void ioc4_unregister_submodule(struct ioc4_submodule
*);
184 #endif /* _LINUX_IOC4_H */