1 #include <net/mac80211.h>
2 #include <net/rtnetlink.h>
4 #include "ieee80211_i.h"
6 #include "driver-ops.h"
9 int __ieee80211_suspend(struct ieee80211_hw
*hw
)
11 struct ieee80211_local
*local
= hw_to_local(hw
);
12 struct ieee80211_sub_if_data
*sdata
;
13 struct ieee80211_if_init_conf conf
;
17 ieee80211_scan_cancel(local
);
19 ieee80211_stop_queues_by_reason(hw
,
20 IEEE80211_QUEUE_STOP_REASON_SUSPEND
);
22 /* flush out all packets */
25 local
->quiescing
= true;
26 /* make quiescing visible to timers everywhere */
29 flush_workqueue(local
->hw
.workqueue
);
31 /* Don't try to run timers while suspended. */
32 del_timer_sync(&local
->sta_cleanup
);
35 * Note that this particular timer doesn't need to be
36 * restarted at resume.
38 cancel_work_sync(&local
->dynamic_ps_enable_work
);
39 del_timer_sync(&local
->dynamic_ps_timer
);
42 list_for_each_entry(sdata
, &local
->interfaces
, list
)
43 ieee80211_disable_keys(sdata
);
45 /* Tear down aggregation sessions */
49 if (hw
->flags
& IEEE80211_HW_AMPDU_AGGREGATION
) {
50 list_for_each_entry_rcu(sta
, &local
->sta_list
, list
) {
51 set_sta_flags(sta
, WLAN_STA_SUSPEND
);
52 ieee80211_sta_tear_down_BA_sessions(sta
);
58 /* flush again, in case driver queued work */
59 flush_workqueue(local
->hw
.workqueue
);
61 /* stop hardware - this must stop RX */
62 if (local
->open_count
) {
63 ieee80211_led_radio(local
, false);
68 spin_lock_irqsave(&local
->sta_lock
, flags
);
69 list_for_each_entry(sta
, &local
->sta_list
, list
) {
70 if (local
->ops
->sta_notify
) {
72 if (sdata
->vif
.type
== NL80211_IFTYPE_AP_VLAN
)
73 sdata
= container_of(sdata
->bss
,
74 struct ieee80211_sub_if_data
,
77 drv_sta_notify(local
, &sdata
->vif
, STA_NOTIFY_REMOVE
,
81 mesh_plink_quiesce(sta
);
83 spin_unlock_irqrestore(&local
->sta_lock
, flags
);
85 /* remove all interfaces */
86 list_for_each_entry(sdata
, &local
->interfaces
, list
) {
87 switch(sdata
->vif
.type
) {
88 case NL80211_IFTYPE_STATION
:
89 ieee80211_sta_quiesce(sdata
);
91 case NL80211_IFTYPE_ADHOC
:
92 ieee80211_ibss_quiesce(sdata
);
94 case NL80211_IFTYPE_MESH_POINT
:
95 ieee80211_mesh_quiesce(sdata
);
97 case NL80211_IFTYPE_AP_VLAN
:
98 case NL80211_IFTYPE_MONITOR
:
99 /* don't tell driver about this */
105 if (!netif_running(sdata
->dev
))
108 conf
.vif
= &sdata
->vif
;
109 conf
.type
= sdata
->vif
.type
;
110 conf
.mac_addr
= sdata
->dev
->dev_addr
;
111 drv_remove_interface(local
, &conf
);
114 local
->suspended
= true;
115 local
->quiescing
= false;
121 * __ieee80211_resume() is a static inline which just calls
122 * ieee80211_reconfig(), which is also needed for hardware
123 * hang/firmware failure/etc. recovery.