usb: io_ti: Make edge_remove_sysfs_attrs the port_remove method.
[linux-2.6/linux-acpi-2.6/ibm-acpi-2.6.git] / include / linux / i2c / pcf857x.h
blob0767a2a6b2f1256746220a9f772efaec82f5c9f7
1 #ifndef __LINUX_PCF857X_H
2 #define __LINUX_PCF857X_H
4 /**
5 * struct pcf857x_platform_data - data to set up pcf857x driver
6 * @gpio_base: number of the chip's first GPIO
7 * @n_latch: optional bit-inverse of initial register value; if
8 * you leave this initialized to zero the driver will act
9 * like the chip was just reset
10 * @setup: optional callback issued once the GPIOs are valid
11 * @teardown: optional callback issued before the GPIOs are invalidated
12 * @context: optional parameter passed to setup() and teardown()
14 * In addition to the I2C_BOARD_INFO() state appropriate to each chip,
15 * the i2c_board_info used with the pcf875x driver must provide its
16 * platform_data (pointer to one of these structures) with at least
17 * the gpio_base value initialized.
19 * The @setup callback may be used with the kind of board-specific glue
20 * which hands the (now-valid) GPIOs to other drivers, or which puts
21 * devices in their initial states using these GPIOs.
23 * These GPIO chips are only "quasi-bidirectional"; read the chip specs
24 * to understand the behavior. They don't have separate registers to
25 * record which pins are used for input or output, record which output
26 * values are driven, or provide access to input values. That must be
27 * inferred by reading the chip's value and knowing the last value written
28 * to it. If you leave n_latch initialized to zero, that last written
29 * value is presumed to be all ones (as if the chip were just reset).
31 struct pcf857x_platform_data {
32 unsigned gpio_base;
33 unsigned n_latch;
35 int (*setup)(struct i2c_client *client,
36 int gpio, unsigned ngpio,
37 void *context);
38 int (*teardown)(struct i2c_client *client,
39 int gpio, unsigned ngpio,
40 void *context);
41 void *context;
44 #endif /* __LINUX_PCF857X_H */