[XFS] 929956 add log debugging and tracing info
[linux-2.6/libata-dev.git] / include / linux / usb_isp116x.h
blob5f5a9d9bd6c2ed77c132e8b8c2f0895340274200
2 /*
3 * Board initialization code should put one of these into dev->platform_data
4 * and place the isp116x onto platform_bus.
5 */
7 struct isp116x_platform_data {
8 /* Enable internal resistors on downstream ports */
9 unsigned sel15Kres:1;
10 /* Chip's internal clock won't be stopped in suspended state.
11 Setting/unsetting this bit takes effect only if
12 'remote_wakeup_enable' below is not set. */
13 unsigned clknotstop:1;
14 /* On-chip overcurrent protection */
15 unsigned oc_enable:1;
16 /* INT output polarity */
17 unsigned int_act_high:1;
18 /* INT edge or level triggered */
19 unsigned int_edge_triggered:1;
20 /* WAKEUP pin connected - NOT SUPPORTED */
21 /* unsigned remote_wakeup_connected:1; */
22 /* Wakeup by devices on usb bus enabled */
23 unsigned remote_wakeup_enable:1;
24 /* Switch or not to switch (keep always powered) */
25 unsigned no_power_switching:1;
26 /* Ganged port power switching (0) or individual port
27 power switching (1) */
28 unsigned power_switching_mode:1;
29 /* Given port_power, msec/2 after power on till power good */
30 u8 potpg;
31 /* Hardware reset set/clear. If implemented, this function must:
32 if set == 0, deassert chip's HW reset pin
33 otherwise, assert chip's HW reset pin */
34 void (*reset) (struct device * dev, int set);
35 /* Hardware clock start/stop. If implemented, this function must:
36 if start == 0, stop the external clock
37 otherwise, start the external clock
39 void (*clock) (struct device * dev, int start);
40 /* Inter-io delay (ns). The chip is picky about access timings; it
41 expects at least:
42 150ns delay between consecutive accesses to DATA_REG,
43 300ns delay between access to ADDR_REG and DATA_REG
44 OE, WE MUST NOT be changed during these intervals
46 void (*delay) (struct device * dev, int delay);