Linux 2.6.38-rc8
[linux-2.6/kvm.git] / drivers / block / cciss_cmd.h
blob35463d2f0ee7ce71d80943105f1594eb556141d4
1 #ifndef CCISS_CMD_H
2 #define CCISS_CMD_H
4 #include <linux/cciss_defs.h>
6 /* DEFINES */
7 #define CISS_VERSION "1.00"
9 /* general boundary definitions */
10 #define MAXSGENTRIES 32
11 #define CCISS_SG_CHAIN 0x80000000
12 #define MAXREPLYQS 256
14 /* Unit Attentions ASC's as defined for the MSA2012sa */
15 #define POWER_OR_RESET 0x29
16 #define STATE_CHANGED 0x2a
17 #define UNIT_ATTENTION_CLEARED 0x2f
18 #define LUN_FAILED 0x3e
19 #define REPORT_LUNS_CHANGED 0x3f
21 /* Unit Attentions ASCQ's as defined for the MSA2012sa */
23 /* These ASCQ's defined for ASC = POWER_OR_RESET */
24 #define POWER_ON_RESET 0x00
25 #define POWER_ON_REBOOT 0x01
26 #define SCSI_BUS_RESET 0x02
27 #define MSA_TARGET_RESET 0x03
28 #define CONTROLLER_FAILOVER 0x04
29 #define TRANSCEIVER_SE 0x05
30 #define TRANSCEIVER_LVD 0x06
32 /* These ASCQ's defined for ASC = STATE_CHANGED */
33 #define RESERVATION_PREEMPTED 0x03
34 #define ASYM_ACCESS_CHANGED 0x06
35 #define LUN_CAPACITY_CHANGED 0x09
37 /* config space register offsets */
38 #define CFG_VENDORID 0x00
39 #define CFG_DEVICEID 0x02
40 #define CFG_I2OBAR 0x10
41 #define CFG_MEM1BAR 0x14
43 /* i2o space register offsets */
44 #define I2O_IBDB_SET 0x20
45 #define I2O_IBDB_CLEAR 0x70
46 #define I2O_INT_STATUS 0x30
47 #define I2O_INT_MASK 0x34
48 #define I2O_IBPOST_Q 0x40
49 #define I2O_OBPOST_Q 0x44
50 #define I2O_DMA1_CFG 0x214
52 /* Configuration Table */
53 #define CFGTBL_ChangeReq 0x00000001l
54 #define CFGTBL_AccCmds 0x00000001l
55 #define DOORBELL_CTLR_RESET 0x00000004l
57 #define CFGTBL_Trans_Simple 0x00000002l
58 #define CFGTBL_Trans_Performant 0x00000004l
60 #define CFGTBL_BusType_Ultra2 0x00000001l
61 #define CFGTBL_BusType_Ultra3 0x00000002l
62 #define CFGTBL_BusType_Fibre1G 0x00000100l
63 #define CFGTBL_BusType_Fibre2G 0x00000200l
64 typedef struct _vals32
66 __u32 lower;
67 __u32 upper;
68 } vals32;
70 typedef union _u64bit
72 vals32 val32;
73 __u64 val;
74 } u64bit;
76 /* Type defs used in the following structs */
77 #define QWORD vals32
79 /* STRUCTURES */
80 #define CISS_MAX_PHYS_LUN 1024
81 /* SCSI-3 Cmmands */
83 #pragma pack(1)
85 #define CISS_INQUIRY 0x12
86 /* Date returned */
87 typedef struct _InquiryData_struct
89 BYTE data_byte[36];
90 } InquiryData_struct;
92 #define CISS_REPORT_LOG 0xc2 /* Report Logical LUNs */
93 #define CISS_REPORT_PHYS 0xc3 /* Report Physical LUNs */
94 /* Data returned */
95 typedef struct _ReportLUNdata_struct
97 BYTE LUNListLength[4];
98 DWORD reserved;
99 BYTE LUN[CISS_MAX_LUN][8];
100 } ReportLunData_struct;
102 #define CCISS_READ_CAPACITY 0x25 /* Read Capacity */
103 typedef struct _ReadCapdata_struct
105 BYTE total_size[4]; /* Total size in blocks */
106 BYTE block_size[4]; /* Size of blocks in bytes */
107 } ReadCapdata_struct;
109 #define CCISS_READ_CAPACITY_16 0x9e /* Read Capacity 16 */
111 /* service action to differentiate a 16 byte read capacity from
112 other commands that use the 0x9e SCSI op code */
114 #define CCISS_READ_CAPACITY_16_SERVICE_ACT 0x10
116 typedef struct _ReadCapdata_struct_16
118 BYTE total_size[8]; /* Total size in blocks */
119 BYTE block_size[4]; /* Size of blocks in bytes */
120 BYTE prot_en:1; /* protection enable bit */
121 BYTE rto_en:1; /* reference tag own enable bit */
122 BYTE reserved:6; /* reserved bits */
123 BYTE reserved2[18]; /* reserved bytes per spec */
124 } ReadCapdata_struct_16;
126 /* Define the supported read/write commands for cciss based controllers */
128 #define CCISS_READ_10 0x28 /* Read(10) */
129 #define CCISS_WRITE_10 0x2a /* Write(10) */
130 #define CCISS_READ_16 0x88 /* Read(16) */
131 #define CCISS_WRITE_16 0x8a /* Write(16) */
133 /* Define the CDB lengths supported by cciss based controllers */
135 #define CDB_LEN10 10
136 #define CDB_LEN16 16
138 /* BMIC commands */
139 #define BMIC_READ 0x26
140 #define BMIC_WRITE 0x27
141 #define BMIC_CACHE_FLUSH 0xc2
142 #define CCISS_CACHE_FLUSH 0x01 /* C2 was already being used by CCISS */
144 /* Command List Structure */
145 #define CTLR_LUNID "\0\0\0\0\0\0\0\0"
147 typedef struct _CommandListHeader_struct {
148 BYTE ReplyQueue;
149 BYTE SGList;
150 HWORD SGTotal;
151 QWORD Tag;
152 LUNAddr_struct LUN;
153 } CommandListHeader_struct;
154 typedef struct _ErrDescriptor_struct {
155 QWORD Addr;
156 DWORD Len;
157 } ErrDescriptor_struct;
158 typedef struct _SGDescriptor_struct {
159 QWORD Addr;
160 DWORD Len;
161 DWORD Ext;
162 } SGDescriptor_struct;
164 /* Command types */
165 #define CMD_RWREQ 0x00
166 #define CMD_IOCTL_PEND 0x01
167 #define CMD_SCSI 0x03
168 #define CMD_MSG_DONE 0x04
169 #define CMD_MSG_TIMEOUT 0x05
170 #define CMD_MSG_STALE 0xff
172 /* This structure needs to be divisible by COMMANDLIST_ALIGNMENT
173 * because low bits of the address are used to to indicate that
174 * whether the tag contains an index or an address. PAD_32 and
175 * PAD_64 can be adjusted independently as needed for 32-bit
176 * and 64-bits systems.
178 #define COMMANDLIST_ALIGNMENT (32)
179 #define IS_64_BIT ((sizeof(long) - 4)/4)
180 #define IS_32_BIT (!IS_64_BIT)
181 #define PAD_32 (0)
182 #define PAD_64 (4)
183 #define PADSIZE (IS_32_BIT * PAD_32 + IS_64_BIT * PAD_64)
184 #define DIRECT_LOOKUP_BIT 0x10
185 #define DIRECT_LOOKUP_SHIFT 5
187 typedef struct _CommandList_struct {
188 CommandListHeader_struct Header;
189 RequestBlock_struct Request;
190 ErrDescriptor_struct ErrDesc;
191 SGDescriptor_struct SG[MAXSGENTRIES];
192 /* information associated with the command */
193 __u32 busaddr; /* physical address of this record */
194 ErrorInfo_struct * err_info; /* pointer to the allocated mem */
195 int ctlr;
196 int cmd_type;
197 long cmdindex;
198 struct list_head list;
199 struct request * rq;
200 struct completion *waiting;
201 int retry_count;
202 void * scsi_cmd;
203 char pad[PADSIZE];
204 } CommandList_struct;
206 /* Configuration Table Structure */
207 typedef struct _HostWrite_struct {
208 DWORD TransportRequest;
209 DWORD Reserved;
210 DWORD CoalIntDelay;
211 DWORD CoalIntCount;
212 } HostWrite_struct;
214 typedef struct _CfgTable_struct {
215 BYTE Signature[4];
216 DWORD SpecValence;
217 #define SIMPLE_MODE 0x02
218 #define PERFORMANT_MODE 0x04
219 #define MEMQ_MODE 0x08
220 DWORD TransportSupport;
221 DWORD TransportActive;
222 HostWrite_struct HostWrite;
223 DWORD CmdsOutMax;
224 DWORD BusTypes;
225 DWORD TransMethodOffset;
226 BYTE ServerName[16];
227 DWORD HeartBeat;
228 DWORD SCSI_Prefetch;
229 DWORD MaxSGElements;
230 DWORD MaxLogicalUnits;
231 DWORD MaxPhysicalDrives;
232 DWORD MaxPhysicalDrivesPerLogicalUnit;
233 DWORD MaxPerformantModeCommands;
234 u8 reserved[0x78 - 0x58];
235 u32 misc_fw_support; /* offset 0x78 */
236 #define MISC_FW_DOORBELL_RESET (0x02)
237 } CfgTable_struct;
239 struct TransTable_struct {
240 u32 BlockFetch0;
241 u32 BlockFetch1;
242 u32 BlockFetch2;
243 u32 BlockFetch3;
244 u32 BlockFetch4;
245 u32 BlockFetch5;
246 u32 BlockFetch6;
247 u32 BlockFetch7;
248 u32 RepQSize;
249 u32 RepQCount;
250 u32 RepQCtrAddrLow32;
251 u32 RepQCtrAddrHigh32;
252 u32 RepQAddr0Low32;
253 u32 RepQAddr0High32;
256 #pragma pack()
257 #endif /* CCISS_CMD_H */