2 # GENERIC -- Generic kernel configuration file for DragonFly/i386
4 # Check the LINT configuration file in sys/config, for an
5 # exhaustive list of options.
7 # $DragonFly: src/sys/config/GENERIC,v 1.51 2007/06/09 03:13:01 dillon Exp $
19 makeoptions DEBUG=-g #Build kernel with gdb(1) debug symbols
21 options MATH_EMULATE #Support for x87 emulation
22 options INET #InterNETworking
23 options INET6 #IPv6 communications protocols
24 options FFS #Berkeley Fast Filesystem
25 options FFS_ROOT #FFS usable as root device [keep this!]
26 options SOFTUPDATES #Enable FFS soft updates support
27 options UFS_DIRHASH #Improve performance on big directories
28 options MFS #Memory Filesystem
29 options MD_ROOT #MD is a potential root device
30 options NFS #Network Filesystem
31 options NFS_ROOT #NFS usable as root device, NFS required
32 options MSDOSFS #MSDOS Filesystem
33 options CD9660 #ISO 9660 Filesystem
34 options PROCFS #Process filesystem
35 options COMPAT_43 #Compatible with BSD 4.3 [KEEP THIS!]
36 options COMPAT_DF12 #Compatible with DragonFly 1.2 and earlier
37 options SCSI_DELAY=5000 #Delay (in ms) before probing SCSI
38 options DEVICE_POLLING # Support mixed interrupt-polling
39 # handling of network device drivers
40 options UCONSOLE #Allow users to grab the console
41 options USERCONFIG #boot -c editor
42 options VISUAL_USERCONFIG #visual boot -c editor
43 options KTRACE #ktrace(1) support
44 options SYSVSHM #SYSV-style shared memory
45 options SYSVMSG #SYSV-style message queues
46 options SYSVSEM #SYSV-style semaphores
47 options P1003_1B #Posix P1003_1B real-time extensions
48 options _KPOSIX_PRIORITY_SCHEDULING
49 options ICMP_BANDLIM #Rate limit bad replies
50 options KBD_INSTALL_CDEV # install a CDEV entry in /dev
51 options AHC_REG_PRETTY_PRINT # Print register bitfields in debug
52 # output. Adds ~128k to driver.
53 options AHD_REG_PRETTY_PRINT # Print register bitfields in debug
54 # output. Adds ~215k to driver.
56 # To make an SMP kernel both SMP and APIC_IO are usually
57 # specified. SMP boxes with severely broken BIOSes which
58 # boot fine for non-SMP builds *might* work in SMP mode
59 # if you define SMP and leave APIC_IO turned off.
61 #options SMP # Symmetric MultiProcessor Kernel
62 #options APIC_IO # Symmetric (APIC) I/O
64 # Debugging for Development
70 #options ACPI_QUIRK_VMWARE # VMware's ACPI-fast24 timer is broken
77 device fdc0 at isa? port IO_FD1 irq 6 drq 2
78 device fd0 at fdc0 drive 0
79 device fd1 at fdc0 drive 1
81 # If you have a Toshiba Libretto with its Y-E Data PCMCIA floppy,
82 # don't use the above line for fdc0 but the following one:
85 # NEW-ATA (NATA) and ATAPI devices
88 device natadisk # ATA disk drives
89 device natapicd # ATAPI CDROM drives
90 device natapifd # ATAPI floppy drives
91 device natapist # ATAPI tape drives
92 device natapicam # Emulate ATAPI devices as SCSI
93 options ATA_STATIC_ID # Static device numbering
94 options PCI_MAP_FIXUP # Needed for NATA
96 # LEGACY ATA and ATAPI devices
97 #device ata0 at isa? port IO_WD1 irq 14
98 #device ata1 at isa? port IO_WD2 irq 15
100 #device atadisk # ATA disk drives
101 #device atapicd # ATAPI CDROM drives
102 #device atapifd # ATAPI floppy drives
103 #device atapist # ATAPI tape drives
104 #device atapicam # Emulate ATAPI devices as SCSI via CAM
105 #options ATA_STATIC_ID #Static device numbering
108 device ahb # EISA AHA1742 family
109 device ahc # AHA2940 and onboard AIC7xxx devices
110 device ahd # AHA39320/29320 and onboard AIC79xx devices
111 device amd # AMD 53C974 (Tekram DC-390(T))
112 device isp # Qlogic family
113 device mpt # LSI-Logic MPT/Fusion
114 device ncr # NCR/Symbios Logic
115 device sym # NCR/Symbios Logic (newer chipsets)
116 options SYM_SETUP_LP_PROBE_MAP=0x40
117 # Allow ncr to attach legacy NCR devices when
118 # both sym and ncr are configured
126 device ncv # NCR 53C500
127 device nsp # Workbit Ninja SCSI-3
128 device stg # TMC 18C30/18C50
131 device scbus # SCSI bus (required)
132 device da # Direct Access (disks)
133 device sa # Sequential Access (tape etc)
135 device pass # Passthrough device (direct SCSI access)
137 # RAID controllers interfaced to the SCSI subsystem
138 device asr # DPT SmartRAID V, VI and Adaptec SCSI RAID
139 device dpt # DPT Smartcache - See LINT for options!
140 device iir # Intel Integrated RAID
141 device mly # Mylex AcceleRAID/eXtremeRAID
142 device ciss # Compaq SmartRAID 5* series
145 device aac # Adaptec FSA RAID, Dell PERC2/PERC3
146 #device aacp # SCSI passthrough for aac (requires CAM)
147 device ida # Compaq Smart RAID
148 device ips # IBM ServeRAID
149 device amr # AMI MegaRAID
150 device mlx # Mylex DAC960 family
151 device twe # 3ware Escalade 7000/8000's
152 device twa # 3ware Escalade 9000's
153 device pst # Promise Supertrack
155 # atkbdc0 controls both the keyboard and the PS/2 mouse
156 device atkbdc0 at isa? port IO_KBD
157 device atkbd0 at atkbdc? irq 1 flags 0x1
158 device psm0 at atkbdc? irq 12
162 # splash screen/screen saver
165 # syscons is the default console driver, resembling an SCO console
166 device sc0 at isa? flags 0x100
167 options SC_PIXEL_MODE # add support for the raster text mode
169 device agp # support several AGP chipsets
171 # Floating point support - do not disable.
172 device npx0 at nexus? port IO_NPX irq 13
174 # Power management support (see LINT for more options)
175 device apm0 at nexus? disable flags 0x20 # Advanced Power Management
177 # PCCARD (PCMCIA) support
183 device sio0 at isa? port IO_COM1 flags 0x10 irq 4
184 device sio1 at isa? port IO_COM2 irq 3
185 device sio2 at isa? disable port IO_COM3 irq 5
186 device sio3 at isa? disable port IO_COM4 irq 9
189 device ppc0 at isa? irq 7
190 device ppbus # Parallel port bus (required)
192 device plip # TCP/IP over parallel
193 device ppi # Parallel port interface device
194 #device vpo # Requires scbus and da
198 device de # DEC/Intel DC21x4x (``Tulip'')
199 device em # Intel PRO/1000 adapter Gigabit Ethernet Card (``Wiseman'')
200 device txp # 3Com 3cR990 (``Typhoon'')
201 device vx # 3Com 3c590, 3c595 (``Vortex'')
203 # PCI Ethernet NICs that use the common MII bus controller code.
204 # NOTE: Be sure to keep the 'device miibus' line in order to use these NICs!
205 device miibus # MII bus support
206 device bce # Broadcom NetXtreme II Gigabit Ethernet
207 device bfe # Broadcom BCM440x 10/100 Ethernet
208 device dc # DEC/Intel 21143 and various workalikes
209 device fxp # Intel EtherExpress PRO/100B (82557, 82558)
210 device pcn # AMD Am79C97x PCI 10/100 NICs
211 device rl # RealTek 8129/8139
212 device re # RealTek 8139C+/8169
213 device sf # Adaptec AIC-6915 (``Starfire'')
214 device sis # Silicon Integrated Systems SiS 900/SiS 7016
215 device sk # SysKonnect GEnesis, LinkSys EG1023, D-Link
216 device ste # Sundance ST201 (D-Link DFE-550TX)
217 device tl # Texas Instruments ThunderLAN
218 device tx # SMC EtherPower II (83c170 ``EPIC'')
219 device vge # VIA 612x GigE
220 device vr # VIA Rhine, Rhine II
221 device wb # Winbond W89C840F
222 device xl # 3Com 3c90x (``Boomerang'', ``Cyclone'')
223 device bge # Broadcom BCM570x (``Tigon III'')
224 device stge # Sundance/Tamarack TC9021 Gigabit Ethernet
227 # 'device ed' requires 'device miibus'
228 device ed0 at isa? disable port 0x280 irq 10 iomem 0xd8000
231 device fe0 at isa? disable port 0x300
236 device wlan # 802.11 support
237 device wlan_ccmp # 802.11 CCMP support
238 device wlan_tkip # 802.11 TKIP support
239 device wlan_wep # 802.11 WEP support
240 # 802.11 TX rate control algorithms
241 #device wlan_ratectl_amrr # AMRR
242 device wlan_ratectl_onoe # Onoe
243 device wlan_ratectl_sample # Sample
245 # Aironet 4500/4800 802.11 wireless NICs. Note: the declaration below will
246 # work for PCMCIA and PCI cards, as well as ISA cards set to ISA PnP
247 # mode (the factory default). If you set the switches on your ISA
248 # card for a manually chosen I/O address and IRQ, you must specify
249 # those parameters here.
251 device awi # PRISM I IEEE 802.11b wireless NIC
252 device ral # Ralink Technology 802.11 wireless NIC
253 # Requires wlan_ratectl_onoe and
254 # wlan_ratectl_sample
255 device rtw # RealTek 802.11 wireless NIC
256 # Requires wlan_ratectl_onoe and wlan_wep
257 # WaveLAN/IEEE 802.11 wireless NICs. Note: the WaveLAN/IEEE really
258 # exists only as a PCMCIA device, so there is no ISA attachment needed
259 # and resources will always be dynamically assigned by the pccard code.
262 # The probe order of these is presently determined by i386/isa/isa_compat.c.
263 device ie0 at isa? disable port 0x300 irq 10 iomem 0xd0000
264 #device le0 at isa? disable port 0x300 irq 5 iomem 0xd0000
265 device lnc0 at isa? disable port 0x280 irq 10 drq 0
266 device cs0 at isa? disable port 0x300
267 device sn0 at isa? disable port 0x300 irq 10
269 # Pseudo devices - the number indicates how many units to allocate.
270 pseudo-device loop # Network loopback
271 pseudo-device ether # Ethernet support
272 pseudo-device sl 1 # Kernel SLIP
273 pseudo-device ppp 1 # Kernel PPP
274 pseudo-device tun # Packet tunnel.
275 pseudo-device pty # Pseudo-ttys (telnet etc)
276 pseudo-device md # Memory "disks"
277 pseudo-device gif # IPv6 and IPv4 tunneling
278 pseudo-device faith 1 # IPv6-to-IPv4 relaying (translation)
280 # The `bpf' pseudo-device enables the Berkeley Packet Filter.
281 # Be aware of the administrative consequences of enabling this!
282 pseudo-device bpf #Berkeley packet filter
284 pseudo-device crypto # core crypto support, used by wlan
287 device uhci # UHCI PCI->USB interface
288 device ohci # OHCI PCI->USB interface
289 device usb # USB Bus (required)
290 device ugen # Generic
291 device uhid # "Human Interface Devices"
292 device ukbd # Keyboard
293 device ulpt # Printer
294 device umass # Disks/Mass storage - Requires scbus and da
296 device uscanner # Scanners
297 device urio # Diamond Rio MP3 Player
298 # USB Ethernet, requires mii
299 device aue # ADMtek USB ethernet
300 device axe # ASIX Electronics USB Ethernet
301 device cue # CATC USB ethernet
302 device kue # Kawasaki LSI USB ethernet
303 device rue # RealTek 8150 based USB ethernet
304 # USB wireless NICs, requires wlan, wlan_ratectl_onoe
305 device rum # Ralink Technology RT2501USB/RT2601USB
306 device ural # Ralink Technology RT2500USB
309 device firewire # FireWire bus code
310 device sbp # SCSI over FireWire (Requires scbus and da)
311 device fwe # Ethernet over FireWire (non-standard!)