manual/main_menu/recording_screen.tex

   1 % $Id$ %
   2 \section{\label{ref:Recording}Recording}
   3 \subsection{\label{ref:while_recording_screen}While Recording Screen}
   4 \screenshot{main_menu/images/ss-while-recording-screen}{The while recording
   5   screen}{}
   6
   7 Entering the \setting{Recording} option in the \setting{Main Menu} brings up
   8 a screen in which you can choose to enter the \setting{Recording Screen} or
   9 the \setting{Recording Settings} (see below). The \setting{Recording Screen}
  10 shows the time elapsed and the size of the file being recorded. A peak meter
  11 is present to allow you set gain correctly. There is also a volume setting,
  12 this will only affect the output level of the \dap{} and does \emph{not}
  13 affect the recorded sound.
  14 \opt{SWCODEC}{
  15 \note{When you start a recording, the hard disk will spin up. This will cause
  16 the peak meters to freeze in the process. This is expected behaviour, and
  17 nothing to worry about. The recording continues during the spin up.}}
  18 \opt{MASCODEC}{The frequency, channels and quality}
  19 \opt{SWCODEC}{The frequency and channels} settings are shown on the last line.
  20
  21 The controls for this screen are:
  22 \begin{table}
  23   \begin{btnmap}{}{}
  24
  25     \ActionStdPrev{} / \ActionStdNext & Select setting.\\
  26     %
  27     \ActionSettingsDec{} / \ActionSettingsInc & Adjust selected setting.\\
  28     %
  29     \ActionRecPause & Start recording.\\
  30                     & While recording: pause recording (press again to
  31                       continue).\\
  32     %
  33     \ActionRecExit  & Exit \setting{Recording Screen}.\\
  34                     & While recording: Stop recording.\\
  35     %
  36     \opt{IRIVER_H100_PAD,IRIVER_H300_PAD,IAUDIO_X5_PAD}{
  37       \ActionRecNewfile & Starts recording.\\
  38                         & While recording: close the current file and open
  39                           a new one.\\
  40     }
  41     %
  42     \ActionRecMenu & Open \setting{Recording Settings} (see below).\\
  43     %
  44     \opt{RECORDER_PAD}{
  45       \ActionRecFTwo & Quick menu for recording settings. A quick press will
  46       leave the screen up (press \ActionRecFTwo{} again to exit), while holding
  47       it will close the screen when you release it.\\
  48     }
  49     %
  50     \opt{RECORDER_PAD}{
  51       \ActionRecFThree & Quick menu for source setting.\\
  52       & Quick/hold works as for \ActionRecFTwo.\\
  53       & While recording: Start a new recording file.\\
  54     }
  55   \end{btnmap}
  56 \end{table}