release/src-rt-6.x.4708/shared/nvram/bcm94712agr-sd-sw.txt

   1 # bcm94712agr board with sdram as l2 switch.
   2 # $Copyright Open Broadcom Corporation$
   3 # $Id: bcm94712agr-sd-sw.txt,v 1.5 2004-12-15 21:09:40 rtrask Exp $
   4 boardtype=0x0451
   5 boardnum=${serno}
   6 # Board revision 3.3
   7 boardrev=0x33
   8 boardflags=0x0288
   9 sromrev=2
  10
  11 # MIPS clock frequency in MHz
  12 clkfreq=200
  13
  14 # 16 MB SDR SDRAM (4 Meg x 16 x 2)
  15 sdram_init=0
  16 sdram_config=0x0022
  17 sdram_refresh=0x0000
  18 sdram_ncdl=0
  19
  20 # Ethernet w/Admtek switch
  21 et0macaddr=00:90:4c:76:${maclo}
  22 et0phyaddr=30
  23 et0mdcport=0
  24
  25 # ADMTek switch mgmt i/f GPIO mapping
  26 gpio5=adm_rc
  27
  28 # No eth1
  29 et1phyaddr=0x1f
  30
  31 # Make the d11 i/f single band
  32 wl0id=0x4320
  33
  34 # 4712 802.11g parameters
  35 il0macaddr=00:90:4c:75:${maclo}
  36 aa0=3
  37 ag0=2
  38 pa0maxpwr=60
  39 pa0itssit=62
  40 pa0b0=0x1486
  41 pa0b1=0xfaa8
  42 pa0b2=0xfe47
  43
  44 # Wireless LED GPIO mapping/behavior
  45 wl0gpio2=0
  46
  47 # Commons wireless parameters
  48 cctl=0
  49 ccode=0
  50
  51 # Bootlaoder variables
  52 dl_ram_addr=a0001000
  53 os_ram_addr=80001000
  54 os_flash_addr=bfc40000
  55 lan_ipaddr=192.168.1.1
  56 lan_netmask=255.255.255.0
  57 scratch=a0180000
  58 boot_wait=on
  59 reset_gpio=7
  60
  61 # Watchdog timer in ms
  62 watchdog=3000
  63
  64 # glue between bootloader and firmware
  65 landevs=et0 wl0 wl1
  66 wandevs=