release/src-rt-6.x.4708/shared/nvram/bcm94710ap-sw.txt

   1 # BCM94710AP board as switch
   2 # $Copyright Open Broadcom Corporation$
   3 # $Id: bcm94710ap-sw.txt,v 1.2 2004-12-15 21:09:35 rtrask Exp $
   4 boardtype=bcm94710ap
   5 boardnum=${serno}
   6
   7 # 4710 CPU clock frequency in Mhz
   8 # Only valid value is 125, anything else defaults to 100Mhz
   9 clkfreq=125
  10
  11 # 4710 SDRAM controller parameters
  12 sdram_init=0x0419
  13 sdram_config=0x0000
  14 sdram_refresh=0x8040
  15 sdram_ncdl=0
  16
  17 # 4710 MAC and PHY parameters
  18 il0macaddr=00:90:4c:48:${maclo}
  19 et0macaddr=00:90:4c:49:${maclo}
  20 et0phyaddr=30
  21 et0mdcport=0
  22 et1macaddr=00:90:4c:4a:${maclo}
  23 et1phyaddr=5
  24 et1mdcport=1
  25
  26 # PMON variables
  27 dl_ram_addr=a0001000
  28 os_ram_addr=80001000
  29 os_flash_addr=bfc40000
  30 lan_ipaddr=192.168.1.1
  31 lan_netmask=255.255.255.0
  32 scratch=a0180000
  33 boot_wait=on
  34
  35 # watchdog set to 3 sec
  36 watchdog=3000
  37
  38 # glue between bootloader and firmware
  39 landevs=et0 et1 wl0 wl1 il0
  40 wandevs=
  41