From 69c38b8fcec823da05f98f6ea98ec2b0013d64e2 Mon Sep 17 00:00:00 2001 From: Kevin Wolf Date: Thu, 19 May 2011 16:42:24 +0200 Subject: [PATCH] ide/core: Remove explicit setting of BM_STATUS_INT BM_STATUS_INT is automatically set during ide_set_irq(), there's no reason to set it manually in addition. There is even one case where the interrupt status bit was set, but no IRQ was raised. This is when the PRD table was reached but there is more data to transfer. The correct behaviour for this case is not to set BM_STATUS_INT. Signed-off-by: Kevin Wolf --- hw/ide/core.c | 7 ++++--- 1 file changed, 4 insertions(+), 3 deletions(-) diff --git a/hw/ide/core.c b/hw/ide/core.c index 45410e81a2..95beb175b3 100644 --- a/hw/ide/core.c +++ b/hw/ide/core.c @@ -430,7 +430,6 @@ void ide_dma_error(IDEState *s) s->error = ABRT_ERR; s->status = READY_STAT | ERR_STAT; ide_set_inactive(s); - s->bus->dma->ops->add_status(s->bus->dma, BM_STATUS_INT); ide_set_irq(s->bus); } @@ -500,8 +499,11 @@ handle_rw_error: n = s->nsector; s->io_buffer_index = 0; s->io_buffer_size = n * 512; - if (s->bus->dma->ops->prepare_buf(s->bus->dma, s->is_read) == 0) + if (s->bus->dma->ops->prepare_buf(s->bus->dma, s->is_read) == 0) { + /* The PRDs were too short. Reset the Active bit, but don't raise an + * interrupt. */ goto eot; + } #ifdef DEBUG_AIO printf("ide_dma_cb: sector_num=%" PRId64 " n=%d, is_read=%d\n", @@ -523,7 +525,6 @@ handle_rw_error: return; eot: - s->bus->dma->ops->add_status(s->bus->dma, BM_STATUS_INT); ide_set_inactive(s); } -- 2.11.4.GIT