From 63f4e7c72a27fb828fe1be3003be6a94519e1c12 Mon Sep 17 00:00:00 2001 From: Lorenz Brun Date: Sat, 24 Dec 2022 03:56:22 +0100 Subject: [PATCH] target/ti-cjtag: make switching to JTAG more reliable The current cJTAG to JTAG switching commands for TI chips are not particularly reliable, especially on chips with accurate timing. On a Raspberry Pi the existing sequence has (depending on cabling and chip) a ~50% chance of working, on a much better-behaved FT2232H it doesn't manage to enable full JTAG at all. This change runs a bunch of test-idle cycles before actually attempting to switch to full JTAG. This makes the switch reliable even at high clock speeds (>100kHz) and from precise sources like the FT2232H. Change-Id: I9293e884bf3e9606d529756ae4483b844d3c39db Reported-by: Phil Wiggum Fixes: https://sourceforge.net/p/openocd/tickets/375/ Signed-off-by: Lorenz Brun Reviewed-on: https://review.openocd.org/c/openocd/+/7419 Tested-by: jenkins Reviewed-by: Antonio Borneo --- tcl/target/ti-cjtag.cfg | 1 + 1 file changed, 1 insertion(+) diff --git a/tcl/target/ti-cjtag.cfg b/tcl/target/ti-cjtag.cfg index d5e13e269..97111f1cc 100644 --- a/tcl/target/ti-cjtag.cfg +++ b/tcl/target/ti-cjtag.cfg @@ -5,6 +5,7 @@ # Read section 6.3 in http://www.ti.com/lit/pdf/swru319 for more information. proc ti_cjtag_to_4pin_jtag {jrc} { # Bypass + runtest 20 irscan $jrc 0x3f -endstate RUN/IDLE # Two zero bit scans and a one bit drshift pathmove RUN/IDLE DRSELECT DRCAPTURE DREXIT1 DRPAUSE -- 2.11.4.GIT