From db2932ecf8dc07f65b410e921f96c5c51170c0ae Mon Sep 17 00:00:00 2001 From: Bruce Allan Date: Mon, 26 Oct 2009 11:22:47 +0000 Subject: [PATCH] e1000e: clear PHY wakeup bit after LCD reset on 82577/82578 Performing a dummy read of the PHY Wakeup Control (WUC) register clears the wakeup enable bit set by an PHY reset. If this bit remains set, link problems may occur. Signed-off-by: Bruce Allan Signed-off-by: Jeff Kirsher Signed-off-by: David S. Miller --- drivers/net/e1000e/ich8lan.c | 10 +++++++++- 1 file changed, 9 insertions(+), 1 deletion(-) diff --git a/drivers/net/e1000e/ich8lan.c b/drivers/net/e1000e/ich8lan.c index aa0ab0eb8c7..ead66510e22 100644 --- a/drivers/net/e1000e/ich8lan.c +++ b/drivers/net/e1000e/ich8lan.c @@ -844,7 +844,7 @@ static s32 e1000_phy_hw_reset_ich8lan(struct e1000_hw *hw) u32 i; u32 data, cnf_size, cnf_base_addr, sw_cfg_mask; s32 ret_val; - u16 word_addr, reg_data, reg_addr, phy_page = 0; + u16 reg, word_addr, reg_data, reg_addr, phy_page = 0; ret_val = e1000e_phy_hw_reset_generic(hw); if (ret_val) @@ -859,6 +859,10 @@ static s32 e1000_phy_hw_reset_ich8lan(struct e1000_hw *hw) return ret_val; } + /* Dummy read to clear the phy wakeup bit after lcd reset */ + if (hw->mac.type == e1000_pchlan) + e1e_rphy(hw, BM_WUC, ®); + /* * Initialize the PHY from the NVM on ICH platforms. This * is needed due to an issue where the NVM configuration is @@ -2229,6 +2233,7 @@ static s32 e1000_get_bus_info_ich8lan(struct e1000_hw *hw) **/ static s32 e1000_reset_hw_ich8lan(struct e1000_hw *hw) { + u16 reg; u32 ctrl, icr, kab; s32 ret_val; @@ -2304,6 +2309,9 @@ static s32 e1000_reset_hw_ich8lan(struct e1000_hw *hw) hw_dbg(hw, "Auto Read Done did not complete\n"); } } + /* Dummy read to clear the phy wakeup bit after lcd reset */ + if (hw->mac.type == e1000_pchlan) + e1e_rphy(hw, BM_WUC, ®); /* * For PCH, this write will make sure that any noise -- 2.11.4.GIT