From e589333f346b58f8da5bb8152e1219c52d375ccc Mon Sep 17 00:00:00 2001 From: Maxim Levitsky Date: Sat, 31 Jul 2010 11:59:23 -0300 Subject: [PATCH] V4L/DVB: IR: extend interfaces to support more device settings LIRC: add new IOCTL that enables learning mode (wide band receiver) Still missing features: carrier report & timeout reports. Will need to pack these into ir_raw_event Signed-off-by: Maxim Levitsky Signed-off-by: Mauro Carvalho Chehab --- .../DocBook/v4l/lirc_device_interface.xml | 16 +++ drivers/media/IR/ir-core-priv.h | 1 + drivers/media/IR/ir-lirc-codec.c | 112 +++++++++++++++++---- include/media/ir-core.h | 12 ++- include/media/lirc.h | 5 +- 5 files changed, 125 insertions(+), 21 deletions(-) diff --git a/Documentation/DocBook/v4l/lirc_device_interface.xml b/Documentation/DocBook/v4l/lirc_device_interface.xml index 0413234023d..68134c0ab4d 100644 --- a/Documentation/DocBook/v4l/lirc_device_interface.xml +++ b/Documentation/DocBook/v4l/lirc_device_interface.xml @@ -229,6 +229,22 @@ on working with the default settings initially. and LIRC_SETUP_END. Drivers can also choose to ignore these ioctls. + + LIRC_SET_WIDEBAND_RECEIVER + + Some receivers are equipped with special wide band receiver which is intended + to be used to learn output of existing remote. + Calling that ioctl with (1) will enable it, and with (0) disable it. + This might be useful of receivers that have otherwise narrow band receiver + that prevents them to be used with some remotes. + Wide band receiver might also be more precise + On the other hand its disadvantage it usually reduced range of reception. + Note: wide band receiver might be implictly enabled if you enable + carrier reports. In that case it will be disabled as soon as you disable + carrier reports. Trying to disable wide band receiver while carrier + reports are active will do nothing. + + diff --git a/drivers/media/IR/ir-core-priv.h b/drivers/media/IR/ir-core-priv.h index 8053e3b8427..a85a8c7c905 100644 --- a/drivers/media/IR/ir-core-priv.h +++ b/drivers/media/IR/ir-core-priv.h @@ -79,6 +79,7 @@ struct ir_raw_event_ctrl { struct lirc_codec { struct ir_input_dev *ir_dev; struct lirc_driver *drv; + int carrier_low; } lirc; }; diff --git a/drivers/media/IR/ir-lirc-codec.c b/drivers/media/IR/ir-lirc-codec.c index 8ca01fd6713..77b5946413c 100644 --- a/drivers/media/IR/ir-lirc-codec.c +++ b/drivers/media/IR/ir-lirc-codec.c @@ -46,7 +46,6 @@ static int ir_lirc_decode(struct input_dev *input_dev, struct ir_raw_event ev) IR_dprintk(2, "LIRC data transfer started (%uus %s)\n", TO_US(ev.duration), TO_STR(ev.pulse)); - sample = ev.duration / 1000; if (ev.pulse) sample |= PULSE_BIT; @@ -96,13 +95,14 @@ out: return ret; } -static long ir_lirc_ioctl(struct file *filep, unsigned int cmd, unsigned long arg) +static long ir_lirc_ioctl(struct file *filep, unsigned int cmd, + unsigned long __user arg) { struct lirc_codec *lirc; struct ir_input_dev *ir_dev; int ret = 0; void *drv_data; - unsigned long val; + unsigned long val = 0; lirc = lirc_get_pdata(filep); if (!lirc) @@ -114,47 +114,106 @@ static long ir_lirc_ioctl(struct file *filep, unsigned int cmd, unsigned long ar drv_data = ir_dev->props->priv; - switch (cmd) { - case LIRC_SET_TRANSMITTER_MASK: + if (_IOC_DIR(cmd) & _IOC_WRITE) { ret = get_user(val, (unsigned long *)arg); if (ret) return ret; + } + + switch (cmd) { + + /* legacy support */ + case LIRC_GET_SEND_MODE: + val = LIRC_CAN_SEND_PULSE & LIRC_CAN_SEND_MASK; + break; + + case LIRC_SET_SEND_MODE: + if (val != (LIRC_MODE_PULSE & LIRC_CAN_SEND_MASK)) + return -EINVAL; + break; - if (ir_dev->props && ir_dev->props->s_tx_mask) + /* TX settings */ + case LIRC_SET_TRANSMITTER_MASK: + if (ir_dev->props->s_tx_mask) ret = ir_dev->props->s_tx_mask(drv_data, (u32)val); else return -EINVAL; break; case LIRC_SET_SEND_CARRIER: - ret = get_user(val, (unsigned long *)arg); - if (ret) - return ret; - - if (ir_dev->props && ir_dev->props->s_tx_carrier) + if (ir_dev->props->s_tx_carrier) ir_dev->props->s_tx_carrier(drv_data, (u32)val); else return -EINVAL; break; - case LIRC_GET_SEND_MODE: - val = LIRC_CAN_SEND_PULSE & LIRC_CAN_SEND_MASK; - ret = put_user(val, (unsigned long *)arg); + case LIRC_SET_SEND_DUTY_CYCLE: + if (!ir_dev->props->s_tx_duty_cycle) + return -ENOSYS; + + if (val <= 0 || val >= 100) + return -EINVAL; + + ir_dev->props->s_tx_duty_cycle(ir_dev->props->priv, val); break; - case LIRC_SET_SEND_MODE: - ret = get_user(val, (unsigned long *)arg); - if (ret) - return ret; + /* RX settings */ + case LIRC_SET_REC_CARRIER: + if (ir_dev->props->s_rx_carrier_range) + ret = ir_dev->props->s_rx_carrier_range( + ir_dev->props->priv, + ir_dev->raw->lirc.carrier_low, val); + else + return -ENOSYS; - if (val != (LIRC_MODE_PULSE & LIRC_CAN_SEND_MASK)) + if (!ret) + ir_dev->raw->lirc.carrier_low = 0; + break; + + case LIRC_SET_REC_CARRIER_RANGE: + if (val >= 0) + ir_dev->raw->lirc.carrier_low = val; + break; + + + case LIRC_GET_REC_RESOLUTION: + val = ir_dev->props->rx_resolution; + break; + + case LIRC_SET_WIDEBAND_RECEIVER: + if (ir_dev->props->s_learning_mode) + return ir_dev->props->s_learning_mode( + ir_dev->props->priv, !!val); + else + return -ENOSYS; + + /* Generic timeout support */ + case LIRC_GET_MIN_TIMEOUT: + if (!ir_dev->props->max_timeout) + return -ENOSYS; + val = ir_dev->props->min_timeout / 1000; + break; + + case LIRC_GET_MAX_TIMEOUT: + if (!ir_dev->props->max_timeout) + return -ENOSYS; + val = ir_dev->props->max_timeout / 1000; + break; + + case LIRC_SET_REC_TIMEOUT: + if (val < ir_dev->props->min_timeout || + val > ir_dev->props->max_timeout) return -EINVAL; + ir_dev->props->timeout = val * 1000; break; default: return lirc_dev_fop_ioctl(filep, cmd, arg); } + if (_IOC_DIR(cmd) & _IOC_READ) + ret = put_user(val, (unsigned long *)arg); + return ret; } @@ -200,13 +259,28 @@ static int ir_lirc_register(struct input_dev *input_dev) features = LIRC_CAN_REC_MODE2; if (ir_dev->props->tx_ir) { + features |= LIRC_CAN_SEND_PULSE; if (ir_dev->props->s_tx_mask) features |= LIRC_CAN_SET_TRANSMITTER_MASK; if (ir_dev->props->s_tx_carrier) features |= LIRC_CAN_SET_SEND_CARRIER; + + if (ir_dev->props->s_tx_duty_cycle) + features |= LIRC_CAN_SET_REC_DUTY_CYCLE; } + if (ir_dev->props->s_rx_carrier_range) + features |= LIRC_CAN_SET_REC_CARRIER | + LIRC_CAN_SET_REC_CARRIER_RANGE; + + if (ir_dev->props->s_learning_mode) + features |= LIRC_CAN_USE_WIDEBAND_RECEIVER; + + if (ir_dev->props->max_timeout) + features |= LIRC_CAN_SET_REC_TIMEOUT; + + snprintf(drv->name, sizeof(drv->name), "ir-lirc-codec (%s)", ir_dev->driver_name); drv->minor = -1; diff --git a/include/media/ir-core.h b/include/media/ir-core.h index a781045aeed..eb7fddf8f60 100644 --- a/include/media/ir-core.h +++ b/include/media/ir-core.h @@ -44,6 +44,8 @@ enum rc_driver_type { * @timeout: optional time after which device stops sending data * @min_timeout: minimum timeout supported by device * @max_timeout: maximum timeout supported by device + * @rx_resolution : resolution (in ns) of input sampler + * @tx_resolution: resolution (in ns) of output sampler * @priv: driver-specific data, to be used on the callbacks * @change_protocol: allow changing the protocol used on hardware decoders * @open: callback to allow drivers to enable polling/irq when IR input device @@ -52,9 +54,12 @@ enum rc_driver_type { * is opened. * @s_tx_mask: set transmitter mask (for devices with multiple tx outputs) * @s_tx_carrier: set transmit carrier frequency + * @s_tx_duty_cycle: set transmit duty cycle (0% - 100%) + * @s_rx_carrier: inform driver about carrier it is expected to handle * @tx_ir: transmit IR * @s_idle: optional: enable/disable hardware idle mode, upon which, - * device doesn't interrupt host untill it sees IR data + device doesn't interrupt host until it sees IR pulses + * @s_learning_mode: enable wide band receiver used for learning */ struct ir_dev_props { enum rc_driver_type driver_type; @@ -65,6 +70,8 @@ struct ir_dev_props { u32 min_timeout; u32 max_timeout; + u32 rx_resolution; + u32 tx_resolution; void *priv; int (*change_protocol)(void *priv, u64 ir_type); @@ -72,8 +79,11 @@ struct ir_dev_props { void (*close)(void *priv); int (*s_tx_mask)(void *priv, u32 mask); int (*s_tx_carrier)(void *priv, u32 carrier); + int (*s_tx_duty_cycle)(void *priv, u32 duty_cycle); + int (*s_rx_carrier_range)(void *priv, u32 min, u32 max); int (*tx_ir)(void *priv, int *txbuf, u32 n); void (*s_idle)(void *priv, int enable); + int (*s_learning_mode)(void *priv, int enable); }; struct ir_input_dev { diff --git a/include/media/lirc.h b/include/media/lirc.h index 42c467c5051..6678a169fd9 100644 --- a/include/media/lirc.h +++ b/include/media/lirc.h @@ -77,6 +77,7 @@ #define LIRC_CAN_SET_REC_FILTER 0x08000000 #define LIRC_CAN_MEASURE_CARRIER 0x02000000 +#define LIRC_CAN_USE_WIDEBAND_RECEIVER 0x04000000 #define LIRC_CAN_SEND(x) ((x)&LIRC_CAN_SEND_MASK) #define LIRC_CAN_REC(x) ((x)&LIRC_CAN_REC_MASK) @@ -145,7 +146,7 @@ * if enabled from the next key press on the driver will send * LIRC_MODE2_FREQUENCY packets */ -#define LIRC_SET_MEASURE_CARRIER_MODE _IOW('i', 0x0000001d, __u32) +#define LIRC_SET_MEASURE_CARRIER_MODE _IOW('i', 0x0000001d, __u32) /* * to set a range use @@ -162,4 +163,6 @@ #define LIRC_SETUP_START _IO('i', 0x00000021) #define LIRC_SETUP_END _IO('i', 0x00000022) +#define LIRC_SET_WIDEBAND_RECEIVER _IOW('i', 0x00000023, __u32) + #endif -- 2.11.4.GIT