From bdfca5025a159c8bb966e3b87b0c084dd1f831a9 Mon Sep 17 00:00:00 2001 From: Andiry Xu Date: Thu, 6 Jan 2011 15:43:39 +0800 Subject: [PATCH] xHCI: prolong host controller halt time limit xHCI 1.0 spec specifies the xHC shall halt within 16ms after software clears Run/Stop bit. In xHCI 0.96 spec the time limit is 16 microframes (2ms), it's too short and often cause dmesg shows "Host controller not halted, aborting reset." message when rmmod xhci-hcd. Modify the time limit to comply with xHCI 1.0 specification and prevents the warning message showing when remove xhci-hcd. Signed-off-by: Andiry Xu Signed-off-by: Sarah Sharp --- drivers/usb/host/xhci-ext-caps.h | 4 ++-- drivers/usb/host/xhci.c | 2 +- 2 files changed, 3 insertions(+), 3 deletions(-) diff --git a/drivers/usb/host/xhci-ext-caps.h b/drivers/usb/host/xhci-ext-caps.h index 78c4edac1db..ce5c9e51748 100644 --- a/drivers/usb/host/xhci-ext-caps.h +++ b/drivers/usb/host/xhci-ext-caps.h @@ -19,8 +19,8 @@ * along with this program; if not, write to the Free Software Foundation, * Inc., 675 Mass Ave, Cambridge, MA 02139, USA. */ -/* Up to 16 microframes to halt an HC - one microframe is 125 microsectonds */ -#define XHCI_MAX_HALT_USEC (16*125) +/* Up to 16 ms to halt an HC */ +#define XHCI_MAX_HALT_USEC (16*1000) /* HC not running - set to 1 when run/stop bit is cleared. */ #define XHCI_STS_HALT (1<<0) diff --git a/drivers/usb/host/xhci.c b/drivers/usb/host/xhci.c index 023175eab07..8dfa67ff5fa 100644 --- a/drivers/usb/host/xhci.c +++ b/drivers/usb/host/xhci.c @@ -93,7 +93,7 @@ void xhci_quiesce(struct xhci_hcd *xhci) * * Disable any IRQs and clear the run/stop bit. * HC will complete any current and actively pipelined transactions, and - * should halt within 16 microframes of the run/stop bit being cleared. + * should halt within 16 ms of the run/stop bit being cleared. * Read HC Halted bit in the status register to see when the HC is finished. * XXX: shouldn't we set HC_STATE_HALT here somewhere? */ -- 2.11.4.GIT